VTech 2425, User Manual

Page: 10 / 39

1 0
Registration and Operation
Registration And Operation Of The 2425 Accessory Handset
Your 2425 system can operate up to 4 Handsets.
The accessory Handset, model 2422, consists of the following:
Setup Of The 2422 Accessory
Handset
1.
Plug the AC power adapter into
an electrical outlet.
2.
Remove the Handset battery
cover by pressing on the indent
and sliding downward.
3.
Place the new battery pack in
the Handset, with the metal
contacts aligned with the charge
contacts in the battery
compartment.
4.
Replace the battery cover by
sliding it upward.
5.
Place the Handset in the Charge
Cradle, and allow it to charge for
12 hours. After the initial charge,
a maintenance charge of 8
hours should be sufficient.
Getting S
tarted
The original Handset that is shipped with your 2425 system will be automatically
registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER
BASE ID to register the new Handset.