5
5
5
GETTING STARTED
POWER SOURCE
The
PAW Patrol Learning Watch
operates using one CR2450
battery. The CR2450 battery included with the product is for demo
purposes only.
BATTERY REMOVAL AND INSTALLATION
NOTE
: For best performance, remove the factory-
installed battery from the
PAW Patrol Learning
Watch
and use a new battery.
1. Make sure the unit is turned
Off
.
2. Find the battery cover located on the back
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Remove the old battery by pulling up on one
end of the battery.
4. Install one new CR2450 battery following the
diagram inside the battery cover.
5. Replace the battery cover and tighten the
screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
batteries.