BUTCHER BLOCK COUNTERTOPS
4
OVERHANG PLACEMENT
Overhangs less than 8” do not require
additional support. If the layout includes
any overhangs 8” or larger, additional
support corbels or brackets will be
required at least every 24”.
CenterPointe backsplash material may be screwed to
the butcher block prior to installation by drilling pilot
holes and screwing from the bottom of the block into
the backsplash material. Attachment to the cabinet base
is not necessary for the attachment of the backsplash.
The number of installation fasteners is to be determined
by the installer. It is recommended that fasteners be put
every 12“-18”.
NOTE: For non-wood backsplash applications, allow a
1/8” gap between the edge of the countertop and the
wall, which will allow it to expand and contract within
the humidity of the kitchen. Use silicone caulking or
trim to fill the 1/8 inch expansion gap.
WOOD BACKSPLASH PLACEMENT
12”
24”
MAX
Side View
End View
8”+
Drill 5/32” Pilot Hole
#10 Wood Screw
12” - 18”
Silicone sealant should be used in sink applications to
form a water tight bond between the countertop and the
sink. To seal top-mount sink openings, apply a thin bead
of silicone caulk under the sink flange. For top-mount
sinks, apply a thin bead of caulk to the top of the sink
flange. The fitting of sinks must not restrict the countertops
from expanding and contracting. Ensure that there is at
least 1/4” clearance all around the sink. For faucet holes/
cutouts, ensure that the hole is a minimum 1/8” larger
than the pipe diameter. Seal the cut edges of the internal
hole with sealer. Finally seal the faucet and hole with a
silicone sealant. To avoid splintering when cutting into
the butcher block, it is recommended that masking tape
be applied over the area that will be cut.
SINK AND FAUCET PLACEMENT
TOP-MOUNT
SINK
CUTOUT
SILICONE
CAULK
Overhead View
Underside Front View
COUNTERTOP
SILICONE CAULK
UNDER-MOUNT
SINK
