FRSky, Version: 1.4
Page 6/16
3.3
Announcement of the settings (Setup)
A variety of settings on the speech module can be made with the keys (see section 5.3), those
will be announced.
4
Vario sound
If a hub + FVAS-01 (variometer sensor) are connected to the receiver - or the "VSpeak Vario"
delivers the measurements, a in the frequence proportional vario sound for rising/falling can be
generated from the speech module during the speech pause. In order to better distinguish
between rising and falling, the tone for the rising is also interrupted. The interruption duration
decreases with increasing climbing. The zero slide, neither rising nor falling, is soundless.
The "Vspeak Vario" sends compared to FrSky-Altimeter FVAS-01 not only the
barometric altitude values, but also the resulting vertical speed determined for the
generation of the Vario signal. In Vspeak Vario an expensive signal processing is realized,
in whose result is a Vario signal can be transmitted with a minimum resolution of 0.1 m/s
For the vario sound a number of settings can be made in the settings (see section 5.3):
Vario sound rising:
ON/OFF
Vario sound falling:
ON/OFF
Vario sensitivity
1, 2, 3 … , 8, 9 (1…highest // 9…lowest sensitivity)
… with connected "Vspeak-Vario":
1, 2, 3 … complies 0.1 m/s
4, 5, 6 … complies 0.2 m/s
7, 8, 9 … complies 0.3 m/s
Vario sound volume:
1, 2, 3, ….. 15, 16, 15, 14, ……3, 2
For a long climb passages, e.g. E-gliders, F-trail, or just during "gymnastics" can the Vario-
sound be switched OFF and the ON again by double-clicking (2x short activation).
5
Operation of the speech module
The speech module VSpeak is operated with the switch (non-latching switch). To check the
function of the key a blue LED is lit for the duration of the operation.
The key can be pressed in four different ways:
5.0
"long key stroke"
If the key is pressed and held (> 2sec) the timed announcement is switched OFF or ON. The
setting is announced, either:
"Timed announcement is OFF" - or - "timed announcement is ON"
Thus, only the cyclically recurring announcements of the reading is switched OFF / ON.
Using "single-click" the announcement can be started anytime. Also, the announcement of the
alarms is done regardless of the setting made here.
The setting is saved.
5.1
"single click"
Using "single-click" (Button 1 x pressed briefly) the "regular announcement" is started
(see section 3.1).
Is the speech module in mode "settings" (see section 5.3), then, by pressing the key, the reading-
switching or changing takes place. In addition, the setting menu can also be stopped.
