Electronic switch 2A (opto)
www.VSpeak-modell.de
Page
3/4
will memorize these positions and switch "ON", as long the signal is within this range.
Remove the magnet when you are done.
4
LED-Display
4.1
internal green LED
OFF:
Switch is OFF
ON:
Switch is ON
Blinking: Magnet near Sensor, switch status is kept on previous state
-or-
Fault, no servo signal for more than 2.5 seconds, switch is "OFF"
Flickering: Programming mode, switch is "ON"
4.2
external blue LED
OFF:
Load is switched "OFF", no connection to the load battery
ON:
Load is switched "ON", power from load battery
5
Technical data
Servo input
3,0 … max 15V
Switching voltage
3,0 … max 20V
(3…13 Cells NiCd/NiMh, 1 to 4 Cells LiPo)
Switch current
max 2 A
Power consumption
(control part, powered by the RX)
ON: about 9 mA
OFF: about. 2 mA
Power consumption
(switching part, powered by the
external battery)
ON: about 8 mA/ 2mA with / without external blue LED
OFF: ~
0 mA
(max. 0,001 mA)
Size
30 x 9 x 8 mm
(PCB)
Weight
6 g (incl. Cable)
Connectors
RX cable (0,14 mm²)
switching part: 3-wire cable (0,25 mm²)
2-pin socket for the external blue LED
The "ON" range can be programmed completely free.