THE LITHIUM CUT / TOOL TIPS
8
MAINS OPERATION
To use the clipper connected to mains power:
• Ensure your new tool is switched off.
• Insert the small plug on the charging adaptor into the socket on the bottom
of your new tool.
• Plug the charging adaptor into a suitable mains power socket and switch on.
• The red LED charging light will flash when the adapter is correctly inserted
into the appliance and connected to an outlet
• Switch the clipper on
- NOTE -
if the battery is weak and low on battery
charge,wait approx.1 min before switching the clipper on.
• NOTE:
The clipper should not be used for longer than 20 minutes when
operated with the cord.
OILING THE BLADES
To get the sharpest, most precise cut, it is highly recommended to oil the blades
before each use.
Using the oil supplied with your new tool, unscrew the cap & cut off the very end
of the plastic tube with a pair of scissors to release the oil.
Switch your tool on, gently squeeze the oil tube & apply 2 drops of oil onto the
blades. Leave the tool on for a further few seconds to allow the oil to thoroughly
spread across each of the blades. Switch off the tool & remove any excess oil by
gently dabbing with a cloth.
