WARRANTY
Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for
a major failure and for compensation for any other reasonably foreseeable
loss or damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not amount
to a major failure.
In New Zealand our goods come with a guarantee that cannot be excluded
under the Consumer Guarantee Act 1993.
Limited Three Year Warranty
Conair Australia Pty Ltd. will repair or replace (at our option) your appliance
free of charge for thirty six months from the date of purchase if the appliance
is defective in workmanship or materials. This warranty is an additional
benefit and does not affect your legal rights. To obtain service under this
warranty, please read the Warranty Leaflet included or contact Conair
Customer Service at [email protected].
To make a warranty claim you must retain your proof of purchase.
HOW TO USE YOUR HOT ROLLERS
• The rollers can be used on damp or dry hair.
• Place the appliance on a level, heatproof surface. Do not open the lid at this time.
• Turn the appliance on by switching the ‘I/0’ button on the back of the unit to
the ‘I’ position.
• One roller has a ‘heat ready dot’ on top. The ready dot will turn from red to
white, indicating optimum temperature has been reached and the rollers are
ready to use. Open the lid for both the rollers and the clips and begin to style
the hair.
• Comb the hair thoroughly and select a roller.
• Take a section of hair the width of the roller and wind the end of the hair around
the roller, holding the hair taut. Keep the roller at right angles to the scalp, to
ensure even curls.
• Secure the roller with one of the heated clips provided.
• Continue until all sections of hair have been styled.
• Turn the appliance off by switching the ‘I/0’ button on the back of the unit to
the ‘0’ position.
• To remove the rollers from the hair, gently hold the roller in one hand and
remove the clip with the other. Slowly unroll the roller, being careful not to pull
on it as you unwind. Once the hair is loose of the roller, let it bounce back up.
• Let the hair cool so that the curl can set for long-lasting results. Once the hair
has cooled style the hair as desired.
• Replace all the clips and rollers back in the unit and close both lids.
• Allow the appliance to cool down completely before storing away.
IMPORTANT !
• Please note the Total Protection Ceramic Heated Rollers have been specifically
designed to reach high temperatures in order to produce fast and perfect curl
formation.
• When applying the rollers to long or thick hair, the rollers can be used instantly
once the heat ready dot has turned white.
• When applying the rollers to short or fine hair, allow the rollers to heat up
until the heat ready dot turns white. Once the heat ready dot has turned
white, turn off the unit and open the lid. Allow the rollers to cool until they feel
comfortable when applying into the hair.
• Always take extra care to avoid the ceramic rollers coming into direct contact
with the scalp.
HELPFUL TIPS
• The tightness and hold of the curl is determined by the length of time the
roller is left in the hair. After several times of using the appliance, the length
of time the rollers should be left in the hair to achieve the desired style will be
established.
• For long, lasting defined curls, the rollers should be left in the hair for a longer
period of time before removing or until the rollers and clips have completely
cooled.
• For softer, glamorous waves the rollers should be left in the hair for a shorter
period of time.
• In all cases we suggest to leave the rollers in the hair for at least 10 minutes.
• After all the rollers have been removed use your fingers to ‘comb’ through the
curls.
• Spray with a soft-holding hairspray. A heavier spray weighs down the hair and
may cause the curls to drop quicker.
WARNING!
• Do not open either lid until the rollers are fully heated (i.e. heat ready dot has
turned white) and ready for use.
• Take care to avoid contact between the hot rollers and the face, neck, eyes or
ears.
• Please do not touch the hot metal parts of the appliance during use.
CAUTION
Heated bars: To avoid heat contact, remove the heated clips from the top bar
first. When replacing the clips on to the heated bars, start with the bottom bar
first.
Vidal Sassoon and related logos are
trademarks of The Procter & Gamble
Company used under license by Conair
©2015 Conair Australia Pty Ltd
Suite 101, 18 Rodborough Rd
Frenchs Forest NSW, 2086
Australia
CUSTOMER SERVICE:
Australia: 1800 650 263
New Zealand: 0800 266 247
CONTACT US:
For advice, tips on your new VS product
E-mail us on: [email protected]
vssassoon.com.au
VS3133A
IMPORTANT SAFETY INSTRUCTIONS
The following safety precautions should always be followed when using
electrical appliances, especially when children are present in your household.
Please read these instructions carefully and keep for future reference.
DANGER
•
WARNING:
Do not use this appliance in or near bathtubs, showers,
basins or other vessels containing water. Keep the appliance dry.
• When this appliance is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the appliance is switched
off.
• If this appliance falls into water, unplug it immediately- DO NOT reach
into the water.
WARNING:
Before and During Use
• Before using, always ensure that the voltage marked on the appliance is the
same as your local power voltage.
• If the appliance is designed to be connected to a detachable power supply
(otherwise known as a charger or adaptor), the appliance must only be
used with the power supply it was sold with.
• Do not operate this appliance or disconnect from the power supply with
wet hands.
• Never use this appliance at the same time as styling products such as
aerosols (spray).
• Be very careful when handling this appliance as parts of it may get
extremely hot.
• Do not place the appliance on any heat sensitive surface or near flammable
materials or objects.
• Keep the cord away from heated surfaces.
• Never block the air openings of the appliance or place on a soft surface
such as a bed or couch, where the air openings may be blocked. Keep the
air openings free of lint and other debris.
• Do not cover this appliance with anything when it is switched on or hot.
• To avoid electric shock, do not drop or insert any object into an opening in
this appliance.
WARNINGS:
for Storage and Maintenance
• Always unplug the appliance immediately after use and before cleaning or
maintenance.
• Do not leave the appliance unattended when plugged in or switched on.
• Always allow the appliance to cool down before storing away in a location
where children cannot reach it.
• Do not store or place this appliance in a location where it can fall or be
pulled into a bath or sink.
• Do not wrap the supply cord around this appliance when storing as over
time this may cause damage to the cord.
• If the supply cord is damaged it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• Never operate this appliance if it has been dropped or damaged, or if it is
not working correctly.
• If this appliance is serviced by an unqualified person this could result in
an extremely hazardous situation for the user. Contact Conair Customer
service if you have any issues operating your styler.
CAUTION
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience
and knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure they do not play with the appliance.
• Use this appliance only for its intended use and as described in this manual.
This appliance is not intended for commercial use.
• Do not use any attachments other than those supplied by Conair Australia
Pty Ltd.
• For additional protection, the installation of a residual current device (RCD)
with a rated operating current not exceeding 30mA is advisable in the
electrical current circuit supplying the bathroom.
Ask your installer for advice.
