Congratulations on the purchase of your new VS Sassoon Smooth
& Wave. The clever 2 in 1 tool that quickly and effortlessly creates
beautiful, soft lasting waves as well as smooth, straight styles all with
the flick of a switch. A revolution in automatic styling technology!
STYLING INSTRUCTIONS
As the Smooth & Wave is a revolutionary new type of styler, it works very
differently to the styling tools you may have used in the past. As such it’s
important to carefully read through the instructions before using for the first
time.
BEFORE USE
• When using the unit for the first time, you might notice a little smoke and
distinct odour: this is common and will disappear by next use.
• Each time you use the appliance, you may see some steam. Do not be
concerned, this could be because of the evaporation of the natural oils of the
hair, residual hair products, or excess moisture evaporating from you hair.
Heat Mat
The appliance comes with a heat mat for use during and after styling.
During use do not place the appliance on any heat sensitive surface, even when using the
heat mat provided. After use, switch off and unplug the appliance. Immediately wrap the
appliance in the heat mat provided and allow to fully cool down. Continue to keep it out of
reach of children as it will remain hot for several minutes.
FEATURES:
1. Ceramic Curl Chamber
2. Floating Ceramic Straightening Plate
3. 3 Temperature Settings (180°C, 200°C, 230°C)
4. Rotation Selector (LEFT, RIGHT OR ALTERNATE)
5. Straight or Wave Setting Selector
6. 2.5m Swivel Cord
INSTRUCTIONS FOR USE
HEAT SETTINGS
If you have delicate, fine or coloured hair, use the lower heat settings.
For thicker hair, use the higher heat settings.
It is suggested to always complete a test on initial use to ensure the correct temperature
is used on the hair type. Start on the lowest setting and increase the temperature until
desired result is achieved.
Below is a guide of the temperature settings:
= OFF
• = 180°C
• • = 200°C
• • • = 230°C
Wave or Straight Settings
The wave or straight setting allows you to switch between the Wave Mode for perfectly
formed waves or straight mode for a sleek finish.
Below is a guide of the wave and smooth settings:
= Wave Mode
= Straight Mode
Wave Direction Settings
The wave direction settings allow you to chose the direction of your wave formation.
Below is a guide of the wave direction settings:-
= Clockwise
= Alternate
= Anti-Clockwise
Sleep Mode
This appliance has an automatic sleep mode feature. If the appliance is not used for more
than 20 minutes the temperature will automatically drop to 150°C. If you wish to continue
using the appliance after this time, simply close then release the handles and it will return
to the temperature setting you were using it on.
Auto Shut Off
This appliance has an automatic shut off feature for added safety. If the appliance is
switched on for more than 60 minutes continuously, it will automatically switch off. If you
wish to continue using the appliance after this time, simply slide the switch to the ‘‘ ’’
setting, then slide the switch to the relevant setting to turn the power on again.
Smooth & Wave
1
6
5
4
3
2
CREATING SMOOTH STYLES
1. The hair should be clean, dry, combed
through and free of dry shampoo, hairspray,
mousse, spray wax, styling dust and all
other styling products. Comb through to
remove any tangles and divide the hair into
sections, no bigger than 3cm wide.
2. Select the straight setting by sliding the
switch to straight mode
3 . Separate a clean section of hair, no bigger
than 3cm wide. When working with naturally
curly or longer length hair, use smaller
sections.
4. Always insert the hair into the appliance
with the plate part facing towards the
head. Place a section of hair between the
straightening plates, close to the roots.
5.
IMPORTANT!
The neat section of hair
must be inserted into the opening, beyond
the hair
stopper (A)
until it reaches
guide (B).
6.
Firmly close
the handles
together to
allow the hair to
start to be drawn into the ceramic chamber.
7.
As soon as the hair starts to be drawn into
the ceramic chamber, holding the hair
firmly between the straightening plates,
immediately slide the appliance down the
length of the hair from root to tip to release
the smooth section of hair.
8.
IMPORTANT!
Do not wait for the hair to be
completely drawn into the chamber before
straightening. Simply clamp and go to
straighten.
CREATING WAVES
1. The hair should be clean, dry, combed
through and free of dry shampoo, hairspray,
mousse, spray wax, styling dust and all other
styling products. Comb through to remove any
tangles and divide the hair into sections, no
bigger than 3cm wide.
2. Select the wave setting by sliding the switch to
wave mode
3. Wave direction can be selected by sliding the
switch to desired direction:
= Clockwise
= Alternate
= Anti-Clockwise
4. Always insert the styler into the hair with the
open part of the
ceramic chamber
facing towards
the head.
5.
I M P O R T A N T !
The neat section
of hair must be
inserted into the
opening, beyond
the hair stopper (A) until it reaches guide (B).
6.
IMPORTANT!
Firmly close the handles
together to allow the hair to be drawn into the
ceramic chamber.
Keep the appliance in position and once
the hair has been drawn into the ceramic
chamber, the appliance will start beeping.
Continue to hold the handles closed until
the appliance sounds finish audio, this is to
indicate the time is up.
7. Release the handles fully and gently move
the styler away from the head to reveal the
wave.
IMPORTANT SAFEGUARD
1. The hair should be clean, dry, combed
through and free of dry shampoo,
hairspray, mousse, spray wax, styling
dust and all other styling products. Comb
through to remove any tangles and divide
the hair into sections, no bigger than 3cm wide.
2. Select the wave setting by sliding the switch
to wave mode
3. Wave direction can be selected by sliding
the switch to desired direction:
= Clockwise
= Alternate
= Anti-Clockwise
4. Always insert the styler into the hair with the
open part of the ceramic chamber facing
towards the head.
5.
IMPORTANT!
The neat section of hair
must be inserted into
the opening, beyond
the hair stopper (A) until
it reaches guide (B).
6.
IMPORTANT!
Firmly close the
handles together to allow the hair to be
drawn into the ceramic chamber.
Keep the appliance in position and once
the hair has been drawn into the ceramic
chamber, the appliance will start beeping.
Continue to hold the handles closed until
the appliance sounds finish audio, this is
to indicate the time is up.
7. Release the handles fully and smoothly pull
the styler away from the head to reveal the
wave.
For more detailed instructions, please refer to the full Instruction Booklet included in the box.
Creating
Waves
PLEASE READ THIS CARD AND INSTRUCTION BOOKLET BEFORE USE
DO NOT RETURN TO STORE
FOR IMMEDIATE ATTENTION PLEASE CONTACT 1-855-926-6247 • www.conaircanada.ca
METÁ e METÁ (half & half)
TM
BY CURL SECRET ®
PLEASE READ THIS CARD AND INSTRUCTION BOOKLET BEFORE USE
DO NOT RETURN TO STORE
FOR IMMEDIATE ATTENTION PLEASE CONTACT 1-855-926-6247 • www.conaircanada.ca
IMPORTANT SAFEGUARD
1. The hair should be clean, dry, combed
through and free of dry shampoo,
hairspray, mousse, spray wax, styling
dust and all other styling products. Comb
through to remove any tangles and divide
the hair into sections, no bigger than 3cm
wide.
2. Select the smooth setting by sliding the
switch to smooth mode
3. Separate a clean section of hair, no bigger
than 3cm wide. When working with
naturally curly or longer length hair, use
smaller sections.
4. Always insert the hair into the appliance
with the plate part facing towards the
head. Place a section of hair between the
straightening plates, close to the roots.
5.
IMPORTANT!
The neat section
of hair must be
inserted into the
opening, beyond
the hair stopper
(A) until it reaches
guide (B).
6.
IMPORTANT!
Firmly close the handles
together to allow the hair to be drawn into
the ceramic chamber.
7.
IMPORTANT!
Once the hair has begun to
be drawn into the ceramic chamber hold
plates and immediately slide down the
length of the hair from root to tip.
For more detailed instructions, please refer to the full Instruction Booklet included in the box.
Creating
Smooth Styles
METÁ e METÁ (half & half)
TM
BY CURL SECRET ®
L-492
PLEASE READ THIS CARD AND INSTRUCTION BOOKLET BEFORE USE
DO NOT RETURN TO STORE
FOR IMMEDIATE ATTENTION PLEASE CONTACT 1-855-926-6247 • www.conaircanada.ca
IMPORTANT SAFEGUARD
1. The hair should be clean, dry, combed
through and free of dry shampoo,
hairspray, mousse, spray wax, styling
dust and all other styling products. Comb
through to remove any tangles and divide
the hair into sections, no bigger than 3cm
wide.
2. Select the smooth setting by sliding the
switch to smooth mode
3. Separate a clean section of hair, no bigger
than 3cm wide. When working with
naturally curly or longer length hair, use
smaller sections.
4. Always insert the hair into the appliance
with the plate part facing towards the
head. Place a section of hair between the
straightening plates, close to the roots.
5.
IMPORTANT!
The neat section
of hair must be
inserted into the
opening, beyond
the hair stopper
(A) until it reaches
guide (B).
6.
IMPORTANT!
Firmly close the handles
together to allow the hair to be drawn into
the ceramic chamber.
7.
IMPORTANT!
Once the hair has begun to
be drawn into the ceramic chamber hold
plates and immediately slide down the
length of the hair from root to tip.
For more detailed instructions, please refer to the full Instruction Booklet included in the box.
Creating
Smooth Styles
METÁ e METÁ (half & half)
TM
BY CURL SECRET ®
L-492
