SERVICE
Vossloh-Schwabe Deutschland GmbH
Stuttgarter Straße 61/1
D-73614 Schorndorf, Germany
Phone: +49 (0)7181 8002-0
For further information please visit our website: www.vossloh-schwabe.com
ENGLISH
EN
Safety notes
!
The Blu2Light products may only be installed and commissioned by authorised specialists. Read these
instructions carefully before installing and commissioning the system. This is the only way to ensure safe and
correct handling. Keep this manual in a safe place so that it may be available at a later date. Before any
work is carried out on the equipment, it must be disconnected from the supply voltage. The applicable safety
and accident prevention regulations must be observed. Improper opening of the products is not permitted,
there is a danger to life due to electrical voltage. Repairs may only be carried out by the manufacturer.
Bluetooth
®
wireless technology
The Bluetooth
®
word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and
any use of such marks by Vossloh-Schwabe is under license. Other trademarks and trade names are
those of their respective owners.
We, Vossloh-Schwabe Deutschland GmbH, herewith confirm that these devices comply with the basic
requirements of the directive 2014/53/EU and other relevant directives. The entire text of the declaration
of conformity can be obtained from the following address: www.vossloh-schwabe.com.
Power supply
This product is powered by a supply voltage of 95–240 V AC.
The fuse must be switched off in order to disconnect the device from the power supply!
Assembly
• Independent mounting
• Support: Firm, no sinking into insulating material
• The torque for the screws of the fastening lugs must be adjusted accordingly depending on the screw
and material.
• Fastening: With the aid of 4 mm screws at least 8 mm long
• The tightening torque of the screw of the plastic cover cap is 0.9 N m.
Installation notes
• Conductor cross-section for all plug-in terminals: 0.75 mm² – 2.5 mm².
• Preparing the cables (see right).
• The unit must be installed so that the user does not have direct access to the relay terminal area after
installation.
• The maximum permissible current is 4 A per channel.
Setup and operation
• The Blu2Light devices have to be configured with the LiNA Connect App and can be operated via
the LiNA Touch App.
• An Apple iPad is required for setup, it is not included in the scope of delivery.
LiNA Connect (configuration)
iOS
iPad
version 13 and higher
LiNA Touch (operation)
iOS
Android
Tablet
version 13 and higher
version 5.0 or higher
Smartphone
version 13 and higher
version 5.0 or higher
Technical Notes
Blu2Light Relais
Ref. No.: 187236
Communication:
Blu2Light mesh network
Frequency range:
2402–2480 MHz
Power consumption (standby):
≤
3 W
Output power:
< 10 mW EIRP
Power supply:
95–240 V AC bei 50/60 Hz
Switching capacity AC max.
4 A / 250 V
Switching capacity DC max.
4 A / 24 V
Ambient temperature t
a
:
5–50 °C
Degree of protection:
IP20
Protection class:
II
Dimensions (LxWxH):
103 x 36 x 22 mm
Casing:
plastic, white
Weight:
59 g
Screw terminals for lead cross section:
0,75–2,5 mm²
Automatic circuit breaker:
B13 (or more sensitive)
Schaltbild / wiring diagram – Blu2Light Relais 2CH
