5
Section 2- USING THE MACHINE
2.1 Connecting your Hose and Accessories
The flexible hose is connected to the vapor outlet on the machine by inserting the proper tube end to the outlet at the
machine’s base (refer to fig. 4).
Turning the locking ring clockwise allows you to connect the accessories. After the accessory is connected, turn the locking
ring counterclockwise. These operations may slightly differ according to the accessories of the machine.
2.2 Generating Vapor
The handle on the end of the hose has a trigger to control the vapor output. By pressing the trigger, vapor comes out;
by releasing the trigger, the output is stopped (refer to fig. 5).
When the “
OK
” green light turns on,
VAPORE 3000 ASPIRA
is ready to generate vapor. However, after the initial
heating, it is advisable to release the air in the system by pressing the trigger on the handle for a few seconds; when the
“OK”
green light turns on again; the machine is ready for optimal usage.
It is advisable not to use the hose without any accessories, as this will lead to the formation of extra condensation
drops.
Note
: Vapor distribution is preceded by a few sprays of water: this is caused by the normal formation of
condensation in a cool hose. It is, therefore, advisable to direct the first distribution on a cloth, to avoid wetting the
surfaces that need to be cleaned.
To fully use
VAPORE 3000 ASPIRA
’s
power, it is advisable to regulate the vapor output according to the accessory
used and to the surface to be cleaned; this is achieved by rotating the regulator knob on the control panel (see section
1.1)
The vapour-only hose (refer to fig. 5) has three positions on top of the handle. When set to different positions it will either
give the user the capability to use the injection pump or not. The positions correspond to the settings as follows:
Position 1: Only vapour
Position 2: Only injection of product (injection pump switch must be switched ON)
Position 3: Vapour and Injection simultaneously (injection pump switch must be switched ON)
2.3 Water Refill in the Tank
When the water in the tank is finished,
VAPORE 3000 ASPIRA
stops the vapor distribution signalling this by
turning the yellow light on (see section 1.1), showing that a water refill is necessary. Thus, remove the tank cap,
paying attention to the probes (refer to fig.6), fill the tank with water and reposition the cap. The machine will be
ready to resume working 3 - 4 seconds later.
It is advisable to perform this operation while the appliance is turned off. Once this operation is done you may then
turn the machine back on (no waiting time is needed).
Figure 4
Figure 5