Installation
(CONT)
Camera Wiring
1. Locate the reverse lamp in the tail light assembly.
2. Using a Digital Multi-Meter, Locate the Reverse Trigger wire. This
wire will test Ground (-) at rest and 12-Volt (+) when vehicle is in
Reverse gear.
3. Connect the RED camera power wire the vehicle reverse trigger
wire.
NOTE:
Some vehicles will not supply enough current to power
the reverse light and the back-up camera. If this is the case an
additional relay and wiring may be required.
4. Connect the BLACK Ground (-) to chassis ground.
Video Signal
1. Route the supplied video cable from the rear of the vehicle to the
display monitor
NOTE:
When routing video cable be sure not to obstruct any
vehicle airbag or safe features.
2. Connect the camera video cable to the monitor camera input.
This input will automatically turn on when the vehicle reverse
gear is engaged.
