20
ENGLI
SH
PLAYING A RECORD
SPEED CHOICE AND ADJUSTMENT
1.You could choose different speed level 33/45/78 ,according to individual request for Vinyl.
2.while the playing speed is not stable( fast or slow,maybe belt is aging or motor problem..),you could re-setup the
correct speed by below adjustment steps.
a. Select the speed 33/45/78.
b. Hold the ON/OFF button for 2 seconds, LED on, enter ADJ. mode.
c. Turn the knob (counterclockwise - to speed down / clo to speed up) to change the platter speed.
d. Press the ON/OFF button again after finish adjusting speed, LED will flash then off. MCU will memorize the speed.
NOTE
: The speed setting should be adjusted by qualified technician.
PLAYBACK IS FINISHED
1. Push the tone arm lifter lever toward the back of the turntable.
2. Move the tone arm back to the tone arm rest.
3. Pull the tone arm lifter lever toward the front of the turntable and secure the tone arm with the tone arm lock.
4. Rotate the SPEED/POWER rotary switch knob to turn off your turntable. The platter stops turning and the
turntable turns off.
REPLACING THE STYLUS
To avoid damaging valuable records, replace the stylus without delay. Purchase a replacement stylus at the store
where you purchased the record player or your nearest repair and inquiry outlet.
NOTE
: The stylus tip is an extremely delicate part, so handle it very carefully. Use a soft brush to gently remove any
dust from the stylus tip.
1. Turn off the amplifier before replacing the stylus, and unplug the signal cord.
2. Turn the lock ring on the arm clockwise and take out the whole headshell.
3. Turn the headshell over and let the stylus be toward upside.
4. Hold the stylus on both sides then pull outward at a slightl angle.
Remove the stylus.
5. Get the new replacement stylus and carefully aligns the cartridge,
then gently push the stylus onto the cartridge body.
6. install the headshell assembly back to the tone arm.
Pull
Align the protrude position.
