14
ENGLISH
BEFORE OPERATION
Handling Precautions
1.Install on a solid, flat surface - but not on top of a
speaker.
2.Install away from high heat, moisture, or direct
sunlight. Avoid dust, dirt, smoke and steam.
3.Install away from a TV set and tuner. To avoid
interference. use an outdoor antenna or turn off the
TV set and tuner.
4.Moisture may condense on the turntable if it is
brought from a cold area to a warm room, or if room
temperature increases rapidly. If so, do not use until
moisture evaporates.
5.To clean records, use an antistatic spray or cleaning
fl uid and soft cloth. Wiping with a dry cloth or brush
may cause static noise.
Power-Cord Caution
Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power
cord when your hands are wet as this could cause a
short circuit or electric shock.
Do not place the unit, a piece of furniture, etc., on the
power cord, or pinch the cord.
Never make a knot in the cord or tie with other cords.
The power cords should be routed such that they are
not likely to be stepped on.
A damaged power cord can cause a fi re or give you an
electrical shock. Check the power cord once in a while.
When you fi nd it damaged, ask your nearest authorized
service center or your dealer for a replacement.
Condensation
When the turntable is brought into a warm room
from previously cold surroundings or when the room
temperature is suddenly increased, condensation may
form inside and the turntable may not be able to attain
its full performance. In cases like this, use the turntable
after allowing it to stand for about an hour or after
raising the room temperature gradually.
Assembly
1.Carefully place the platter on the center spindle, and
align one of its openings over the motor pulley position.
2.Tear the fi ber tape off.
3.While holding both ends of the ribbon on the turntable
belt, carefully pull the belt over the motor pulley. Be
sure it does not twist.
4.Remove the ribbon.
5.Once the belt is seated in the pulley’s groove, the fi ber
tape can be torn off.
6.Remove another one ribbon.
7.Place the mat on top of the platter.
8.Remove the tie securing the tonearm.
9.Remove the stylus guard.
Connections
Before connecting the unit it is advised that you also
consult your current equipment instruction manual.
NOTE
: Be sure to turn off the equipment before you
make changes to the different connections.
1.Connect the power cord to an AC outlet.
2.Connect the RCA cable to the PHONO input of your
amplifi er.
Output terminals
Amplifi er(Receiver)
L (White)
L Channel
R (Red)
R Channel
NOTE
: You can also use a line input by setting the phono
/ line switch at the rear of the turntable to line.
3.Connect PC via USB cord.
PC
S e t t h e P H O N O / L
I
N E
s w i t c h t o “ P
H
O N E ＂ .
S e t t h e P H O N O
/
L I N E
s w i t c h t o
“
L I N E
”
.
FU716 (021014) .indd 章節2:14
FU716 (021014) .indd 章節2:14
2014/3/3 下午 05:49:56
2014/3/3 下午 05:49:56
