6 / 8
When the switch is pressed, the compact system is operated mono. If the switch is released the
Stereo is operated. In mono mode, only one input should be used. At the outputs in each case located
on the same signal. The signal is increased by 3 dB.
10. TO SATELLITE
To connect the JAM TOP.
11. ON/OFF switch
12. Fuse
Only replace the fuse when the device is disconnected from mains.
13. Power input
4. Connections
4.1. Electrical connections
If you wish to change the power supply settings, see the chapter Appendix. Connect the fixture to the
mains with the enclosed power cable and plug. The earth has to be connected.
Cable (EU)
Cable (US)
Pin
International
Brown
Black
Live
L
Light blue
White
Neutral
N
Yellow/Green
Green
Earth
5. Control
1. Before you turning on the power switch, please make sure the mixer is turned on and the input
signal is turned to minimum. Please turn the knob of SAT LEVEL and SUB LEVEL to
minimum.
2. When the power is on the power LED lights up.
3. Choose the right EQ preset. .
4. Choose the operating modes.
5. During operation, please make sure that the speakers always sound well. When distortions
can be heard, either amplifier or speakers are overloaded. Overloads can be quickly caused
damages to amplifier or speaker
6. After usage, set SAT LEVEL and SUB LEVEL controls to the left stop position, then turn off
power switch.
If u want to use the System in 1.1 Mode, with one Bass and 2 Tops
per Side please make sure the DSP Setting 1.1 is choosen and put
the System to Mono Mode.
The Tops can be stacked with the supplied fittings, so that the
Tweeters are near to each other.
