voxicon P45WL, User Manual

Page: 5 / 7

9 8
Trouble Shooting
1. Make sure you have put the batteries in correction directions, and power switch is
ON.
2. Make sure you have connected the receiver correctly to the computer's USB port.
3. Try another USB port, in case that your USB port is loose.
4. Replace new batteries if needed when the battery power is low.
5. If mouse performance is slow or intermittent around a wireless network, unplug
the Nano receiver from the USB port and then re-insert it. To reactivate the mouse,
switch it on, off and on again using the On/Off switch on the bottom of the mouse.
6. Repeat the connection procedure. You can also try moving the mouse closer to
the Nano receiver.
7. Try other working surface which the mouse is operating on.
8. For the best performance, we suggest that you place the receiver away from other
electrical devices.
Battery Use Reminders
1. Remove worn-out batteries from equipment immediately and dispose of them
properly.
2. Keep all batteries (used or new) out of the reach of children.
3. Never dispose of batteries in fire.
4. Do not mix old and new batteries. Do not mix alkaline, standard (Carbon-Zinc), or
rechargeable (Nickel Cadmium) batteries.
5. Remove the batteries from this device if the device will not be used for a long
period of time.
6. If the performance of the battery decreases substantially, it is time to replace the
battery.
FCC Statement
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation if this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment.
(Example-use only shielded interface cables when connecting to computer or peripheral
devices).
This symbol on the product or in the instructions means that your electrical and electronic
equipment should be disposed at the end its life separately from your household waste.
There are separate collection system for recycling in the EU.
For more information, please contact the local authority or your retailer where you
purchased the product.
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTION.
This product uses non-rechargeable alkaline batteries.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference. And
2)
This device must accept any interference received, including interference
that may cause undesired operation.