9
Rear Panel
1. POWER OUTPUT jacks
This is where you can hook up an extension or external speaker cabinet(s) if desired.
16 OHM Speaker jack
Use this to connect the AC30HW60/AC15HW60 to internal speaker or any 16 ohm Cabinet.
8 OHM Speaker jacks
Use these to connect the AC30HW60/AC15HW60 to one 8 ohm Cabinet, or internal speaker and 16 ohm
Cabinets.
WARNING!
To ensure that your system works correctly, you must observe the following points.
a) If using a 16ohm extension cabinet, both the internal speaker and the external cabinet must be con-
nected to the 8 ohm jacks.
b) Don’t connect a speaker whose rated input capacity is less than 30 watts (for AC30HW60) or 15 watts
(AC15HW60). The speaker may be destroyed if you ignore this caution—not recommended!
c) You must use a speaker cable to connect an external speaker. Don’t use a shielded cable like the one
you use to connect a guitar to an amp.
d) You must turn off the power before connecting the speaker cable. Connecting the cable while the power
is turned on may damage your amp.
e) When turning the power on, the speaker(s) need to be connected or damage to the amplifier can occur.
NOTE!
It is recommended that all audio cables (with the exception of the speaker lead), used to connect to
the AC30HW60/AC15HW60 are of a high quality, screened type. These should not exceed 10 metres in
length.
2. FOOT SWITCH jack
This is where you connect the included “Egg” Foot Switch to switch the VIB/TREM Effect On and OFF.
3. MAINS INPUT connector
This is where the supplied, detachable Mains (power) cord is connected. The specific mains input voltage rat-
ing that your amplifier needs to run at is located on the rear panel of your amplifier. Before making any con-
nections or powering up the amplifier, make sure the correct voltage is set. If you have any doubt, refer to
your local VOX dealer.
