The following section describes the normal display driver installation
procedures for Windows 95/98. Use the following procedures when
installing the display drivers for Windows 95/98.
1.
Click
Start
, then
Settings
, then
Control Panel
.
2.
Double click
Display
.
3.
Select the
Settings
tab, click the
Change Display Type
button.
4.
Click the
Change
button under
Adapter Type
.
5.
Click the
Have Disk
button and press
OK
.
6.
Specify the path to the new driver and press
<ENTER>
:
Example 1: Insert the driver CD in the CD-ROM drive, and enter
d:\vga\ct69000\win95 (assuming D: is the CD-ROM drive.)
Example 2: If you're not sure exactly where the drivers are, click the
Browse
button to find them.
7.
The
Select Device
dialog box will appear. Select the hardware that
corresponds to the one you installed in your machine and click
OK
.
8.
Windows 95/98 will copy the display drivers to the proper
directories on your system.
9.
Continue by choosing
Close
. You will be asked to restart your
machine. Do so accordingly.
10.
After the system has restarted, you can go back into the
Display
applet and select alternate screen resolutions and color depths.
Installing the VGA Drivers for Windows NT 4.0
Once you are in the Windows NT 4.0 environment, follow the procedures
below to install the VGA drivers that come with your board.
Page 8
Jumpers and Connectors
JP2: LCD Power Setting
3.3V Setting
5V Setting
JP3: Onboard LAN Enable/Disable
JP3
Setting
LAN
Pin 1-2
Short/Closed
Enabled
Pin 2-3
Short/Closed
Disabled
JP4: Onboard C&T VGA Enable/Disable
JP4
Setting
VGA Function
Pin 1-2
Short/Closed
Enabled
Pin 2-3
Short/Closed
Disabled
* The SW1 DIP Switch is for manufacturing test only.
Page 5
