2000W Convector heater with thermostat, fan
All the above instructions for models VHS-30CT
WALL MOUNTING
The heater is supplied with 4 off each fixing brackets, screws and plastic wall plugs to enable it to be mounted onto
a wall if required.
If it is decides to mount the heater on the wall, the feet should not be fitted. The position must be chosen carefully.
It must not be in front of or below a power socket. It must not be below a shelf, curtains or any other obstruction.
Also refer to the safety instructions overleaf.
Having decided on the location of the heater it is necessary to drill 2 fixing holes 8mm diameter by 43mm deep at
486mm centers on a horizontal line at a minimum height of 400mm from the floor.
Allowance must be made for any floor coverings, carpet etc. and if any skirting boards are present, the fixing holes
must be a minimum of 400mm above the top edge of the skirting board. Using the plastic plugs and fixing screws
provided, attach 2 of the fixing brackets to the wall. The other pair of fixing brackets must be attached to the base
of the heater using the feet retaining screws so that the brackets project out at the rear of the heater and space the
bottom edge away from the wall.
If required, these brackets may also be secured to the wall using the remaining fixing screws and plastic wall plugs.
If this option is chosen it is suggested that the heater is hung on the upper brackets and the hole positions for the
lower brackets is then marked on the wall, prior to drilling the holes for attachment purposes.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth. Do not use any detergents or
abrasives and do not allow any water to enter the heater.