!
Keycode Programming Instructions
*1
:
Step 1. Choose a layer (Fn+
<
,
>
or
?
key) you want to edit the keycodes.
Step 2. Press Fn + Right CTRL to enter the programming mode (Spacebar right LED steadily lit)
Step 3. Select a desire key you want to program (Spacebar right LED flashing)
Step 4. Key in the programming contents and then press Pn(Spacebar right LED steadily lit again) Step
5. Repeat step 2 and step 3 to program other keys.
Step 6. Press Fn + Right CTRL to exit programming mode (Spacebar right LED off)
More:
· Support Fn layer programming, you can select the Fn combination key (e.g., Fn + A) to program it
· Support time delay, press 15ms key (Fn + T) each time to delay 15ms, press 0.1s key (Fn + G) each time
to delay 0.1s, press 0.5s key (Fn + B) each time to delay 0.5s. Consecutive delay will add up but will only
be counted as 1 key stroke.
· Every key can program up to 32 key strokes.
· If there is no key pressed for 15 sec in programming mode, it will back to normal mode.
Note:
*1
Default layer, R_ctrl, M,<,> and
?
keys are fixed can’t be
programmed.
Restore to factory
default:
Current layer:
Press
and hold Fn + R
All
layers:
Press and hold both Alt keys, it will clean all the layers’ program key codes.
Remark:
1.
When you reset the current layer or all layers, the spacebar left LED will flash at the after 5 seconds
then it will return to default.
2.
If you had changed the Fn position and forgot where it was. You still can press the
original
position of
Fn + R to restore it.
