8
English
touch Screen controls:
Power Button
Press to turn unit ON or OFF, red light illuminates when power is ON.
heat Mode
To select the heat level you desire, press HIGH HEAT for up to 1500
watts, or LOW HEAT for up to 750 watts of maximum power.
Fan only Mode
Select FAN ONLY mode to operate the heater with no heat.
Set temperature
To select the desired room temperature, press the (
+
) or (
–
) to raise
or lower the temperature by one degree at a time.
Room temperature
The Touch Screen also indicates room temperature. The temperature
displayed is the approximate temperature at the location of the
Smart Remote. The base unit will always attempt to operate using
Controls
the sensor information from the Remote, if a signal cannot be
obtained, the base unit will function on its own. (See Smart Remote
Temperature Sensor below.)
timer
The timer function allows you to set the unit to automatically turn
off in one-hour intervals up to 9 hours. Press the (
+
) to add hours
of operation, or the (
–
) to remove hours of operation. The unit will
completely shut off when the set time has expired.
Smart Remote controls:
Power
Press the ON/OFF button to turn the unit ON or OFF.
heat Mode
Press the HEAT UP or HEAT DOWN arrows to adjust heat settings one
degree at a time.
timer
Press the TIMER UP or TIMER DOWN arrows to adjust timer by one
hour at a time.
Mode
Press the center MODE button to select HIGH HEAT, LOW HEAT or
FAN ONLY.
Battery Replacement
Screen will indicate when the batteries need to be replaced. The
Remote requires 2 AA batteries. To replace the batteries remove the
cover located on the bottom side of the remote. Note: The SMART
REMOTE SENSOR sends frequent signals to the base unit; this
uses more power than ordinary remotes so more frequent battery
replacement will be required.