8
EN
WWW.VONROC.COM
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm2. If you use an
extension cable reel, always fully unroll the
cable.
2. MACHINE INFORMATION
Intended use
This machine is intended for polishing and brushing
metal and coated surfaces.
TECHNICAL SPECIFICATIONS
This manual has been drawn up for
different sets / article numbers. Check the
corresponding article number in below
specifications table for the correct
composition and contents of your set.
Model No.
Batteries included Chargers included
PM508DC
-
-
S_PM508DC
CD801AA
CD802AA
S2_PM508DC 2 x CD801AA
CD802AA
S3_PM508DC CD803AA
CD802AA
MACHINE INFORMATION
Voltage
20V
No-load speed
3000/min
Disc diameter
240 mm
Weight
2.5 kg
Sound pressure level LPA
77.5dB(A), K=3dB(A)
Sound power level LWA
88.5dB(A), K=3dB(A)
Vibration
Handle with switch button ah
31.889m/s² K=1.5m/s²
Handle without switch button ah 21.336m/s² K=1.5m/s²
Model No.
CD801AA
Battery Type
Lithium-Ion
Voltage
20V
Capacity
2.0 Ah
Recommended charger
CD802AA
Weight
0.3 kg
Model No.
CD803AA
Battery Type
Lithium-Ion
Voltage
20V
Capacity
4.0 Ah
Recommended charger
CD802AA
Weight
0.65 kg
Model No.
CD802AA
Charger input
220-240V, 50Hz 0.4A
Charger output
21V 2.5A
Charging time 2Ah battery
60 minutes
Charging time 4Ah battery
120 minutes
Recommended batteries
CD801AA, CD803AA
Weight
0.36 kg
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other bat-
teries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.