VONROC 8717479072040, Original Instructions Manual

Page: 6 / 28

6
EN
WWW.VONROC.COM
• Keep children and animals away from the appli-
ance if you are using it.
Immediately switch off the appliance when:
• Plug and/or cable are defective or damaged;
• The switch is defective;
• You smell or see smoke caused by scorched
insulation from the hot air gun.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class II machine - Double insulation - You
don’t need any earthed plug
2. MACHINE INFORMATION
Intended use
This hot air gun is intended for a wide range of
applications including plastic welding, the defor-
mation of material, heat-shrink tubing, removing
material residues or drying paint. It is also suitable
for loosening of adhesive joints and the defrosting
of water lines.
TECHNICAL SPECIFICATIONS
Model No. HA501AC
Voltage 220-240 V~
Frequency 50 Hz
Power input 2000 W
Weight 0.66 kg
IP Class IP 20
Position I
Air flow
250 l/min
Air temperature 400 °C
Position II
Air flow
500 l/min
Air temperature 600 °C
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work pat-
terns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3
Fig. A-C
1. Switch
2. Ventilation slots
3. Nozzle outlet
4. Fishtail nozzle
5. Reduction nozzle
6. Glass protection nozzle
7. Flat rear side
3. OPERATION
The Hot air gun can be used for:
• Plumbing work like tube connections, solder,
bowing tubes;
• Removing paint, varnish and lacquer without
firerisk;
• Quickly drying of appliances which have beco-
me wet;
• Drying surfaces for quick repairing;
• Removing self-adhesive labels in a clean way
placing PVC labels;
• Blistering after sticking PVC materials can be
smoothed after heating;
• Easy removing of vinyl carpeting:
• Forming all synthetics with a low temperature (400
degrees) among which polyethylene and PVC;
• Forming all synthetics with a high temperature
(600 degrees) among which acryl and plexiglass;