MATERIAL PREPARATION
Stir the spraying material thoroughly before
measuring viscosity.
Dip the
VISCOSITY CUP (14)
completely into the
spraying material.
Hold the
VISCOSITY CUP (14)
and measure the time
in seconds until the spray material empties out.
This time duration is referred to below as *
Runout
Time.
IMPORTANT
Before spraying, the material
being used may need to be thinned
with solvent; as specified by the material
manufacturer.
WARNING
Do not use materials with a
flashpoint below 39°C.
NOTE
Follow the instructions below.
14
MATERIAL
THINNING CHART
*RUNOUT TIME (SEC)
OIL ENAMEL
OIL BASED PRIMER
OIL STAIN
CLEAR SEALER
POLYURETHANE
VARNISH
25 - 40
30 - 45
NO THINNING REQUIRED
NO THINNING REQUIRED
NO THINNING REQUIRED
20 - 50
Impurities in the paint may give poor
performance and a poor finish.
IMPORTANT
Material to be sprayed should
always be strained to remove any impurities in
the paint which may enter and clog the system.
