OPERATION
CLEANING & CARE
BULB REPLACEMENT
The bulbs fitted to this Heater are
220-240V ~
50Hz 25W G9 halogen bulbs.
Due to the indeterminate life span and ease
of replacement, the light bulbs are specifically
excluded from the guarantee.
Unplug from the mains supply and allow to
completely cool.
Open the door and locate the two screws, unscrew
both and keep safe.
Pull the Log Bed from both ends to lift up the
Log Bed decoration. The two bulbs are located
underneath.
Remove the defective bulb by pulling it out of the
holder.
Replace with a new bulb.
CAUTION:
Take care not to touch the bulb with bare
hands and ensure that the bulb is pushed in correctly.
To reassemble, follow the above instructions in
reverse order.
CAUTION:
Always disconnect the Heater from the electricity supply and allow it to cool before undertaking
maintenance or replacing the bulb.
CAUTION:
Switch off the Heater and disconnect the
plug from the power socket. Wait for the Heater to
cool completely before cleaning.
To remove dust on external surfaces, wipe the Heater
with a damp (not wet) lint-free cloth rinsed in hot
soapy water only.
CAUTION:
Do not use any harsh detergent or
abrasive cleaners.
WARNING!
Do not spray with any liquids or
submerge in liquid or water.
WARNING!
Do not attempt to clean the inside of the
Heater. Do not attempt to open the Heater casing at
any time. There are no user-serviceable parts.
Insert the plug into mains socket.
TO ACTIVATE THE HEATING FUNCTION:
Turn the Thermostat Dial to maximum by turning
clockwise and switch on the Fan Switch.
For Low Heat – Activate 1 Heat Switch
For High Heat – Activate the second Heat Switch
(1850W combined).
Turn down the Thermostat Control Knob to the
desired temperature by turning anticlockwise.
Close the door once you have finished adjusting the
settings.
CAUTION
Do not knock the Stove Heater over when in use
as this could cause damage to the filiments of the
bulbs.
6
