4
INSTALLING THE FIRE-
FREESTANDING:
Locate the Fireplace in a suitable area ensure that it is
kept 1m clear of any combustible objects, plug into a
suitable outlet.
FULL INSET:
NOTE:
Screws not supplied for inset fittings.
Remove the 4 screws located at the back of the
Fireplace to remove the metal frame and convert into
an inset Fireplace.
Mark the centre of the opening of the fireplace.
Measure 215.5mm to the left and then again to the
right. From this point measure from the floor 560mm
upwards. Once measured mark these positions on
the wall.
Drill the holes using a suitable sized drill and insert
suitable screws leaving 2mm of the screw visible.
Once both screws are in place lift the Fireplace onto
the screws and set down in place.
When installing the Fireplace ensure the correct
measurements are used for sufficient ventilation use
the table below as a guide.
Dimension
Minimum
Maximum
Width
400mm
483mm
Height
560mm
590mm
Depth
125mm
125mm
2mm
400mm
125mm
560mm
