4.0 BATTERY INSTALLATION:
The battery backup consists of one (1) 12V 1.2 or 1.3AH lead acid battery. Connect the red and black wires
to the battery, being careful to connect red to
+
(positive) and black to
-
(negative) terminals on the battery.
Place the battery in the bottom of the enclosure in an
upright position only
to complete the installation.
5.0 KEYLOCK:
The keylock option (PS9) consists of a one (1) piece lock with two (2) keys. Use the following installation
steps to properly install this option.
5.1
Remove the keylock knockout located on the enclosure door with a screwdriver.
5.2
Rotate the key fully clockwise in the lock then insert the lock through the knockout with the
locking lever pointing toward the right hand side of the door. Snap into place.
941062_00(1) Page 2 of 2
Figure 1.
PS9 Typical Wiring Application
ELECTRIC HINGE OR
POWER TRANSFER
BLK
RED
PS9 POWER SUPPLY
DEVICE
Wire colors are
intentionally
swapped at the
splices.
Note:
*
AC
GROUND
LUG
DANGER - Charge only Von Duprin specified
lead acid battery. Other types of batteries may
burst causing personal injury and damage.
Observe the proper polarity when connect-
ing the battery. See Figure 1.
D
D
D
D
DANGER
ANGER
ANGER
ANGER
ANGER
!
