7
6
Technical certificate
Extra package insert
Ridge shape
1
2,10
Top draw band
1
6,76
Bottom draw band
2
0,60
Bottom arc base sheet
2
0,83
Top arc base sheet
2
2,91
Outermost base sheet for a runner
2
2,04
Tingle
18
0,094
Main shape
2
2,10
Washer 32х6
12
Bolt М6х14
32
Bolt М6х20
12
Bolt М6х60
2
Nut М6
46
Washer 6
48
Double-size scotch tape
1
5 м
Таблица 4
Technical certificate
The greenhouse should be serviced in the winter period. The greenhouse has
durability under the action of snow loads way more than is required for greenhouses,
but less for some snow areas in comparison with the general construction standards.
According to SNiP 2.10.04-85 «Greenhouses and seedbeds» «weight of snow blanket
on 1 m2 of horizontal surface of the ground in design of static greenhouses…» should
be taken from 10 to 40 kg/m2 depending on a snow region. This is much less than
the general construction standards for snow load, because it is assumed that on the
current greenhouses a snowcap is not preserved until the next snowfall. According
to the results of strength tests the limits of durability of the greenhouse frame
are revealed: destroying snow load is 360 kg/m2, permissible load (with safety
coefficient 1.4) – 260 kg/m2. The permissible load approximately corresponds to
the thickness of fresh snow 0.9 m and settled snow 0.45 m. Thus, in operation it is
necessary to prevent accumulation of snowcaps above specified limits.
If the greenhouse is not heated in winter, or it is supposed to use the greenhouse
as an unheated housing, awning, warehouse, etc., it is necessary to control the
snowcap (to shift the snow down with a wooden or plastic scraper, installed on a
pole). For these variants of operation it is possible to supply reinforced frames with
a reduced interval between the power arcs under the snow load specified by the
customer.
Do not allow damage to the frame, and if it happened, then hold timely repairs.
RULES OF OPERATION
Cleaning and washing of polycarbonate sheets.
1. Rinse sheet with warm water.
2. To remove dirt, wash it with mild soap solution or domestic detergent using a soft
cloth or sponge.
3. To remove water, rinse the sheet with cold water and wipe it with a soft cloth.
Never use abrasives or high-alkali detergents for cleaning
polycarbonate sheets. Dry wiping damages covering layer of
the covering and shortens its service life. Never rub surface of
polycarbonate sheets with a brush, metalized fabric or other abrasive
materials.
Do not use sulphur cartridges for disinfecting greenhouse
against fungal and bacterial agents in order to prevent
corrosion (darkening) of the frame.
It is not allowed to install the greenhouse without fastening on the ground because
of the large sail area of the greenhouse and the possibility of floating away the
unfastened greenhouse
1. The manufacturer bears responsibility for the greenhouse frame complete
setup.
2. The manufacturer bears responsibility for the greenhouse
assemblability in accordance with the manual.
3. The manufacturer bears responsibility for the greenhouse durability under
specified magnitude of atmospheric actions.
4. Claim presentation period is 12 months from the date of purchase.
WARRANTY LIABILITIES
Warranty conditions
Warranty liabilities do not apply to cases of:
1. Greenhouse installation with violation of requirements of the manual.
2. Violation of the rules of operation.
3. Inappropriate use of the greenhouse.
4. Floods, hurricanes and other natural disasters.
Manufacturer: VOLYA LLC,
per. Severny, 8, Dubna, Moscow region, 141983, Russia.
The manufacturer bears responsibility for quality of products in accordance with RF CC. The
manufacturer reserves the right for greenhouse
engineering design changes.
Date of manufacture:
It is not allowed to install the greenhouse without fastening on the ground because
of the large sail area of the greenhouse and the possibility of floating away the
unfastened greenhouse.
