Volvo XC60 Twin Engine 2020, Owner'S Manual

Page: 488 / 714

||
STARTING AND DRIVING
486
Slippery driving conditions
To achieve optimum roadholding Volvo recom-
mends using winter tyres on all wheels if there
is a risk of snow or ice.
NOTE
The use of winter tyres is a legal require-
ment in certain countries. Studded tyres
are not permitted in all countries.
Practise driving on slippery surfaces under
controlled conditions to learn how the car
reacts.
Related information
•
Winter tyres (p. 590)
•
Snow chains (p. 591)
•
Braking on gritted roads (p. 452)
•
Braking on wet roads (p. 452)
•
Filling washer fluid (p. 676)
•
Starter battery (p. 635)
•
Replacing windscreen wiper blades
(p. 674)
•
Replacing the wiper blade, rear window
(p. 673)
•
Topping up coolant (p. 632)
•
Adverse driving conditions for engine oil
(p. 688)
Driving in water
Wading means the car being driven through
water, e.g. on a flooded road. Driving in water
must be performed with great caution.
Observe the following to prevent damage to
the car when driving through water:
•
The water level must not be higher than
the floor of the car. If possible, check the
depth at the deepest point before starting
to drive through the water. Extra caution
should be exercised when passing
through flowing water.
•
Always change to Off Road drive mode
before driving through water in order to
ensure that the internal combustion
engine is running.
•
Do not drive faster than walking pace.
•
Do not stop the car in the water. Drive for-
ward carefully or reverse the car back out
of the water.
•
Remember that waves created by oncom-
ing traffic may rise above the level for the
floor of the car.
•
Avoid driving through salt water (corrosion
risk).
IMPORTANT
Parts of the car (e.g. engine, gearbox,
driveline or electrical components) may be
damaged when driving through water with
a level higher than the floor of the car.
Damaged caused to a component caused
by submersion, hydrolock or lack of oil is
not covered by the warranty.
In the event of stalling in water, do not try
to restart. Instead, tow the car out of the
water and transported on a low loader to a
workshop. An authorised Volvo workshop
is recommended.
When the water has been passed, depress the
brake pedal lightly and check that full brake
function is achieved. Water and mud for
example can make the brake linings wet
resulting in delayed brake function.
If necessary, clean the contact for the trailer
coupling after driving in water and mud.
Related information
•
Recovery (p. 505)
•
Low speed control (p. 478)