Volvo XC 60 TWIN ENGINE, Owner'S Manual

Page: 406 / 620

||
STARTING AND DRIVING
* Option/accessory. 404
NOTE
To reach level I or II without starting the
engine - do not depress the brake pedal, or
the clutch pedal for cars with manual gear
changing, when these ignition positions are to
be selected.
•
Ignition position I - Turn the start knob
clockwise and release it. The control auto-
matically returns to its starting position.
•
Ignition position II - Turn the start knob
clockwise and hold it in position for
approx. 4 seconds. Then release the knob,
which automatically returns to its starting
position.
•
Back to ignition position 0 - To return to
ignition position 0 from position I and II -
Turn the start knob clockwise and release.
The control automatically returns to its star-
ting position.
Related information
•
Starting the car (p. 404)
•
Switching off the car (p. 406)
•
Driver display (p. 92)
Starting the car
The car is started using the start knob in the tun-
nel console when the remote control key is in
the passenger compartment.
Start knob in the tunnel console.
WARNING
Before starting:
•
Fasten the seatbelt.
•
Adjust the seat, steering wheel and mir-
rors.
•
Make sure that the brake pedal can be
fully depressed.
The remote control key is not physically used
when starting the car since it is equipped with
support for keyless starting (Passive start).
To start the car:
1. The remote control key must be inside the
car. For cars with Passive Start, the key
needs to be located in the front part of the
passenger compartment. With keyless lock-
ing/unlocking of the car
*
, the key can be
anywhere in the car.
2. Hold the brake pedal depressed
1
fully. For
cars with automatic gear changing, make
sure that gear position
P or N is selected.
For cars with a manual gearbox, make sure
that the gear lever is in neutral position or
that the clutch pedal is depressed.
3. Turn the start knob clockwise and release it.
The control automatically returns to its star-
ting position.
When the engine is started the starter motor
works until the engine is started or until its over-
heating protection triggers.
When starting in normal conditions, the car's
electric drive motor is prioritised - the petrol
engine remains switched off. This means that
after the start knob has been turned clockwise,
the electric motor has "started" and the car is
ready to drive. A started car is indicated by the
1 If the car is moving, the engine can be started by turning the start knob clockwise.