Volvo TSI, Manual

Page: 245 / 250

Group 28 Service Procedures
Service Procedures
2841-03-02-01
Engine ECU, Replacement
Special tools: 9998482
1
Note: Make sure that the parking
brake is applied.
2
Disconnect the power with main switch
Before working on a vehicle, set the parking brakes,
place the transmission in neutral, and block the
wheels. Failure to do so can result in unexpected
vehicle movement and can cause serious personal in-
jury or death.
WARNING
Fuel leaked or spilled onto hot surfaces or electrical
components can cause a fire. Clean up fuel spills im-
mediately.
.
3
T2014053
Remove the connector from the con-
trol unit by pressing the catch and
pushing the handle up.
4
Cut the clamps round the cable har-
ness under the control unit and fold
away the connector for the control unit.
5
T2014052
Remove the bolts for the cooling coil
on the control unit.
Note: Do not release the fuel lines on
the cooling coil.
6
Remove the control unit’s hold-down
bolts (4, see previous illustration ) and
lift off the control unit.
7
Install the new control unit.
Note: Make sure that the framework
line is positioned correctly and that the
mating surface on the engine block is
free from rust.
If the control unit is painted where the
cooling coil is to be installed: Remove
the paint where the cooling coil is in
contact with the control unit to ensure
maximum cooling.
8
Install the cooling coil on the control
unit.
9
Check the clamping force of the termi-
nal in the connector for the control unit
by means of gauge 9998482.
9998482
10
Install the connector on the control
unit. Make sure that the catch locks on
the connector.
243