Volvo S90 - ACCESSORY PANEL, Owner'S Manual Supplement

Page: 121 / 166

PRACTICAL INFORMATION
119
Driver's side bulb housing shown
1. Remove the low beam round rubber cover
from the headlight housing.
2. Remove the connector from the bulb.
3. Remove the bulb by pressing it slightly
upward and then pulling it out.
4. Insert the bulb in the socket. The bulb's guid-
ing pin should point straight up.
5. Press the connector into place.
6. Put the rubber cover back into place.
Related information
•
Replacing bulbs (p. 116)
•
Bulb specifications (p. 123)
Replacing High Beam headlight
bulbs
On models with halogen headlights, the High
Beam headlight bulb can be replaced by the
owner.
Before the bulb can be accessed, the headlight
housing's cover must be removed, see the article
"Replacing bulbs."
CAUTION
Never touch the glass of bulbs with your fin-
gers. Grease and oils from your fingers vapor-
ize in the heat and will leave a deposit on the
reflector, which will damage it.
Driver's side bulb housing shown
1. Remove the high beam round rubber cover
from the headlight housing.
2. Remove the bulb by turning the bulb holder
upward and then pulling it straight out.
3. Carefully pry the plastic sleeve by the con-
nector's locking lug to release it.
4. Remove the connector from the bulb.
5. Replace the bulb.
6. Position the bulb in the socket and turn it
downward.
7. Put the rubber cover back into place.
Related information
•
Bulb specifications (p. 123)
•
Replacing bulbs (p. 116)