9A
IMG-246829
9B
IMG-246830
9C
IMG-260591
Illustration A shows the removal of the cover for the load
securing eyelets
Fold out the load securing eyelet.
Insert a scriber with an angled tip into the hole in the top of the
cover.
Turn the scriber so that the angled tip engages in the reverse of
the cover (1). Pull the cover off.
Illustration B applies to cars with two rows of seats
If the car is equipped with a 12 V socket, remove its connector.
Illustration C applies to cars with three rows of seats
Fold up the seats in the third row (applies to cars with three rows
of seats).
Remove the screws (2) for the load securing eyelets in the right-
hand side panel.
Remove the covers (3) over the front mountings for the right-
hand side panel. Pry the covers off. Use a plastic weatherstrip
tool or a small screwdriver.
Remove the screws (4).
Remove the panel by pulling out the upper edge slightly so that
the clips on the inside release. Pull the panel straight up.
If the car is equipped with a 12 V socket, remove its connector.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Satellite radio, Sirius- 31201184 - V1.3
Page 8 / 21
