29A
IMG-279965
29B
IMG-279966
Illustration A
Select a Ø14 mm (9/16") hole saw.
Swap the central drill bit in the hole saw for a Ø5 mm (13/64")
drill bit. The hole in the holder is larger than the diameter of the
drill bit. Therefore, wrap tape around the end of the drill bit to
make sure it sits firmly in place in the hole. Do not lock the
central drill bit with the lock screw. The drill bit must only be
used for guiding the hole saw because the holes in the
dashboard's lower part cannot be larger than Ø5 mm (13/64").
Illustration B
Fit a 13 mm (33/64") drill stop
Drill out for the cradle's three feet.
Note!
Only drill through the vinyl layer and foam layer, not through
the plastic layer (1) on the lower part of the dashboard as this
will make the hole too large for the nuts that are to be
tightened from underneath.
Note!
Do not damage the dashboard.
30
IMG-279967
Select a Ø25 mm (1") hole saw.
Change the centre drill in the hole saw back to the original drill
bit.
Drill for the connection of the connector. Drill through all layers
of the dashboard. Use a 25 mm (1")drill stop.
Note!
Do not damage the dashboard.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Mobility Connection Package- 31285543 - V1.1
Page 22 / 84