2
IMG-217441
Turn the steering wheel a quarter turn so that the holes on the
reverse of the steering wheel are accessible.
3
IMG-217560
Insert a screwdriver in the hole (2) on the reverse of the steering
wheel, at right angles to the rear surface of the steering wheel.
Insert the screwdriver as far as possible to determine the
position of the end of the spring clip (1).
Position the end of the screwdriver on the top of the spring clip
as illustrated.
Pry the screwdriver upwards towards the upper edge of the hole
(2) so that the end of the screwdriver presses the spring clip
down (1) until one side of the steering wheel module springs out
and releases from the mounting.
Turn the steering wheel a half turn in the opposite direction.
Carry out the same operation on the other side.
Turn the steering wheel to a neutral position.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Cruise control- 30739998 - V1.1
Page 7 / 13
