Volvo 2016 XC 90 Twin Engine, Owner'S Manual

Page: 488 / 582

WHEELS AND TIRES
* Option/accessory, for more information, see Introduction. 486
Removing a wheel
Wheel changes should always be carried out
correctly.
1. Turn on the hazard warning flashers if the
wheel change has to be done near passing
traffic.
2. Apply the parking brake and put the gear
selector in
P
.
CAUTION
Models with suspension and level con-
trol
*
:
Turn this function off before raising the vehi-
cle.
To do so, go to
Settings Vehicle
Deactivate Suspension & Leveling Control
in the center display's Top view.
WARNING
•
The jack must correctly engage the jack
attachment.
•
Be sure the jack is on a firm, level, non-
slippery surface.
•
Never allow any part of your body to be
extended under a vehicle supported by a
jack.
•
Use the jack intended for the vehicle when
changing a tire. For any other job, use
stands to support the vehicle.
•
Apply the parking brake and put the gear
selector in the Park (
P
) position.
•
Block the wheels standing on the ground,
use rigid wooden blocks or large stones.
•
The jack should be kept well-greased and
clean, and should not be damaged.
•
No objects should be placed between the
base of jack and the ground, or between
the jack and the attachment bar on the
vehicle.
NOTE
The jack provided with your vehicle is
intended to be used only in temporary situa-
tions such as changing wheels in the event of
a flat tire. Only the jack that came with your
particular model should be used to lift the
vehicle. If the vehicle needs to be lifted more
frequently or for a prolonged period, using a
garage jack or hoist is recommended. Always
follow this device’s instructions for use.
3. Take out the jack
*
, lug wrench
*
, the tool for
removing the plastic covers on the wheel
bolts and the towing eyelet stowed under the
floor of the cargo compartment.
Tool for removing the plastic covers on the wheel bolts
Remove the plastic covers on the wheel bolts.
4. Block the wheels that are on the ground with
wooden blocks or large stones.