Volvo 2016 XC 90 Twin Engine, Owner'S Manual

Page: 261 / 582

DRIVER SUPPORT
}}
* Option/accessory, for more information, see Introduction. 259
Activating ACC (putting it in active
mode and setting a speed)
Before ACC can be put in active mode:
•
The driver's seat belt must be buckled and
the driver's door must be closed.
•
There must be a vehicle ahead (a target vehi-
cle) or your vehicle's current speed must be
at least 10 mph (15 km/h).
–
With the symbol displayed (ACC is in
standby mode), press the button (1) on
the left-side steering wheel keypad.
> This puts ACC in active mode and sets
the vehicle's current speed, which is indi-
cated by digits in the center of the speed-
ometer.
The
time interval
to the vehi-
cle ahead will only be shown
when two vehicles are dis-
played.
A speed interval will also be
indicated:
•
The higher speed is the one set in ACC
•
The lower one is the speed of the vehicle
ahead (the target vehicle).
Related information
•
Adaptive Cruise Control (ACC)
*
(p. 256)
•
Setting an Adaptive Cruise Control time
interval (p. 262)
•
Deactivating/resuming Adaptive Cruise
Control (ACC) (p. 259)
Deactivating/resuming Adaptive
Cruise Control (ACC)
ACC can be put temporarily in standby mode
and then reactivated.
Deactivating and putting ACC in
standby mode
If ACC is in standby mode and your vehicle
comes too close to the vehicle ahead, the driver
will be warned by the Distance Alert system
instead.