2005 VOLVO XC90
●
Refer to the garage door opener owner's manual for verification.
●
If your hand-held transmitter appears to program the HomeLink® Universal Transceiver but the
programmed button does not activate the garage door, your garage door opener may have a rolling code.
●
Press the programmed HomeLink® button. If the garage door opener has the rolling code feature, the
HomeLink® indicator light flashes rapidly and then glows steadily after approximately 2 seconds.
To train a rolling code garage door opener,
follow these instructions after programming the desired transceiver button according to "Programming
the transceiver." The help of a second person may make training easier.
1. Locate the training button on the garage door opener motor head unit. The location and color of the
training button may vary. If you encounter difficulty, refer to the garage door opener owner's manual or
call toll-free 1-800-355-3515 (Internet:
www.HomeLink.com
).
2. Press the "training" button on the garage door opener motor head unit until the "training" light comes
on.
3. Press and release the programmed HomeLink® button. Press and release the programmed
HomeLink® button a second time to complete the training process.
4. Some garage door openers may require you to do this procedure a third time to complete the training.
5. The programmed button on your HomeLink® Universal Transceiver should now operate your garage
door opener. The original hand-held transmitter can also be used, as desired, to operate the garage door.
The remaining two HomeLink® buttons can be programmed in the same way. In the event of any
problems in programming the HomeLink® Universal Transceiver, call toll-free 1-800-355-3515
(Internet:
www.HomeLink.com
).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used in place of your handheld
transmitters.
To operate, the key must be turned to the "accessory" position (II) or the engine must be running. Press
the programmed HomeLink® button to activate the garage door, driveway gate, security lighting, home
security system, etc.
pg. 198 Audio
Your original hand-held transmitters may, of course, be used at any time.
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed buttons:
1. Turn the ignition key to the "accessory" position (II).
2. Hold down the two outside buttons on the HomeLink® Universal Transceiver for about 20 seconds,
until HomeLink®'s indicator light begins to flash.
file:///K|/ownersdocs/2005/2005_XC90/05xc90_11b.htm (10 of 11)12/30/2006 4:42:44 PM