2001 Volvo S80
To operate, the key must be turned to the "accessory" position (II) or the engine must be running. Press
the programmed HomeLink® button to activate the garage door, driveway gate, security lighting, home
security system, etc.
Your original hand-held transmitters may, of course, be used at any time.
pg.148 HomeLink® Universal Transceiver (option)
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed buttons:
1. Turn the ignition key to the "accessory" position (II).
2. Hold down the two outside buttons on the HomeLink® Universal Transceiver for about 20 seconds,
until HomeLink®'s indicator light begins to flash.
3. Release both buttons.
The HomeLink® buttons can be reprogrammed using the procedures described on the previous pages.
Reprogramming a single HomeLink® button
1. Press and hold the desired HomeLink® button. Do not release the button until step 3 has been
completed.
2. When the indicator light begins to flash slowly (after approximately 20 seconds), position the hand-
held transmitter 2 to 5 in. (5 to 12 cm) away from the HomeLink® surface.
3. Press and hold the hand-held transmitter button. The HomeLink® indicator light will flash first
slowly, then rapidly. When the indicator light flashes rapidly, release both buttons.
The previously programmed device has now been erased and the new device can be activated by
pressing the HomeLink® button that has just been programmed. This procedure will not affect any other
programmed HomeLink® buttons.
NOTE:
· Retain the original transmitter(s) for future programming procedures (i.e., if you purchase a new car).
file:///K|/ownersdocs/2001/2001_S80/01s80_11.htm (4 of 5)12/30/2006 3:48:33 PM
Summary of Contents for 2001 S80
Page 199: ...2001 Volvo S80 ...
