1987 Volvo 780
WARNING!
●
The jack's hook must engage the pin in the jack attachment (A). The car's weight must not rest on
top of the jack's hook (B).
●
Be sure the jack is on firm and level ground.
●
Never allow any part of your body to be extended under a car supported by a jack.
●
Use the jack intended for the car when replacing a wheel. For any other job, use stands to support
the end of the car being worked on.
●
Apply the parking brake, select position P (automatic transmission), or 1st gear or reverse on
manual transmission.
●
Block the wheels standing on the ground. Use rigid wooden blocks or large stones.
●
The jack should be kept well-greased.
Installing the wheel
Clean the contact surfaces on the wheel and hub. Lift the wheel and place it on the hub. Make sure that
you align the wheel with the guide stud on the wheel hub prior to installation. Install the wheel nuts
clockwise and tighten lightly. The bevelled side of the nuts should face the wheel. Lower the vehicle to
the ground and alternately tighten the nuts to 63 ft. lbs. (85 Nm). Install the wheel cap.
pg. 65 Replacing bulbs
NOTE:
The method for replacement of bulbs in the various lighting units is shown on the following pages.
Make sure when installing bulbs, that the guide pin on the socket fits into its corresponding recess.
When installing Halogen bulbs, do not touch the glass with your fingers. The reason for this is that
grease, oil or any other impurities can be carbonized onto the bulb and damage the reflector.
Use bulbs of correct type and voltage. Failure to do so could cause the bulb failure warning light to
activate.
pg. 66 Replacing bulbs
file:///K|/ownersdocs/1987/1987_780/87780_05.htm (5 of 20)12/30/2006 7:56:29 AM
