Engine Oil, Change
Always follow the recommended oil change interval.
Use an oil drain pump (optional) to pump the oil out of
the oil pan.
WARNING!
Hot oil and hot surfaces can cause burns.
WARNING!
Working with or approaching a running engine is a
safety risk. Watch out for rotating components and hot
surfaces.
1 Run the engine until warm so that the oil is easier
to pump. Then stop the engine.
2 Connect a suitable hose to the drain pump
discharge (
1
) and lead it to a collection vessel.
3 Open the tap (
2
) under the drain pump to the
position for draining engine oil (
E
).
4 Replace the oil filter and by-pass filter at every oil
change. Refer to the section
5 Close the tap (
S
). Refill with new oil to the correct
level.
IMPORTANT:
Only use oil of recommend quality and viscosity.
Refer to
for oil quantity
and quality and viscosity.
6 Start the engine and let it idle. Check the oil
pressure. Check that no leaks are present at the
filters.
7 Stop the engine. Wait a few minutes before
checking the oil level. Top up as needed.
Hand in the old oil and filters to a recycling station.
Maintenance
58
47711740 05-2019 © AB VOLVO PENTA
Summary of Contents for D16
Page 1: ...Operator s manual D16 genset ...
Page 86: ......
Page 88: ......
Page 90: ...AB Volvo Penta SE 405 08 Göteborg Sweden www volvopenta com 47711740 English 05 2019 ...
