29
77. Oil the rocker arm and fit the rocker arm cover
together with new gaskets. Fit the intake
manifold and gasket and install the air cleaner.
Fit the ventilation hose between the rocker arm
cover and air cleaner.
NOTE! Fit the intake manifold with the flange
displaced towards the reverse gear side in order
to provide space for the air cleaner.
78. Fit the V-belts and tension the alternator. The
belts are properly tensioned when they can be
depressed under normal thumb pressure about
3 - 4 mm (1/8”). Depress between the start-
generator and flywheel.
79. Fit the key in the crankshaft. Heat the flange and
fit it on the shaft. Tighten it up with the bolt and
the thick washer. Tightening torque: 80 Nm (8
kpm = 57 lbftf). Bend down the thin washer over
the bolt head. Fit the rubber damper.
80. Install the reverse gear and gasket and connect
up the cooling water hose between the reverse
gear and water pump. Then fit the exhaust
elbow.
81. Fill the engine and reverse gear with oil. Concer-
ning the oil quantity and quality, see under
“Technical Data”.
