VOLTOMAT HEATING QH-104263.1, Manual

Page: 32 / 36

QH-104263.1 GBR
ASSEMBLY AND ELECTRIC CONNECTION

Remove both safety elements on the front grid, used as transport protection.

The quartz heater must be installed in a horizontal position only. Do not install at the ceiling or vertically.
During installation respect the minimum distances indicated in Fig. 1.

Find the most appropriate position so as not to block access to the pull switch cord and the switch, at all
times respecting the safety distances indicated in Fig. 1. Mark the holes for mounting on the wall where
the heater is to be installed: 80 mm for the horizontal position and 105 mm for the vertical position. Fix
the quartz heater with the attached dowel screws to the wall.

After assembly and electric installation on the wall the upper part can be swivelled to an angle of max.
55°.

Arrange a convenient angle for the device and fix the mechanism by tightening both lateral screws (Fig. 2).

Now you can use the quartz heater.
Note:
The heater must not be mounted less than 1800mm above the floor, less than 500mm under the ceiling, less
than 200mm away from side wall(s) and less than 1000mm away from bathtub/shower vertically if required.
Fig. 1
Fig. 2
CLEANING

Let the quartz heater cool down and clean it only with dry cloth. Do not touch the quartz tubes with your
fingers!

Never use water and never touch the heater with wet hands.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption: 1500W
Recycling
This marking indicates that this product should not be disposed with other household wastes
throughout the 2012/19-EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental safe recycling.