Page 5
After turning the power on the Chime Box will scan through all camera inputs to
detect the presence of cameras.
Choosing the Mode
Auto Cycle Mode: Automatically switches between cameras.
Manual Cycle Mode: User can manually switch between cameras
Cycle time: The time it takes to switch between the cameras when in “Auto” mode
(2-30 seconds)
The Chime box powers up in Auto cycle mode with a cycle time of 4 seconds, the
status LED lights up GREEN to indicate Auto mode. Any unused camera inputs will
be ignored during camera selection, both auto cycle and manual.
You can manually select the camera view by pressing the manual button, the
status LED lights up RED to indicate manual mode. Pressing the auto button
returns the monitor to auto cycle mode.
USING THE CHIME BOX
Status LED
Beep-
Auto
Talk
Door
Green: Auto cycle
Red: Manual cycle
Manual
Beep+
Page 6
Motion Detection
The full alarm sounds only when a new event is detected. A shorter reminder alarm
sounds if motion continues in front of the same camera. However if the Chime Box
changes to the other camera the full alarm will sound.
The current view is paused for a minimum of 2 seconds even if the monitor de-
tects motion on the other camera. This allows for a stable picture when recording
with a VCR.
If movement is detected by the PIR sensor the chime box will bleep to bring your
attention to the fact someone is outside your property. You can then select the correct
TV channel to view the area.
The alarm volume can be adjusted upwards or downwards by holding down
the + or - buttons.
Using two way speech
Note: Camera view is locked when the talk button is pressed and the status LED
flashes orange.
To use the two way speech feature you must have a two way camera connected to
the chime box. If you require to speak with your visitors press and hold the talk
button and speak clearly into the chime box. To hear your visitors reply release the
talk button. ( To increase the volume of the camera microphone the chime box has
a volume control on the side of the box.)
Status LED Flashes
Orange
Press and hold
“Talk” Button to
speak
