55
f) Continuity test
make sure that all circuit parts, circuits and components and other objects of
measurement are disconnected from the voltage and discharged.
- Turn the DMM on and select measuring range
.
Press “MODE” button to switch measurement
functions. The symbol for continuity test now
appears in the display. Pressing this button again
takes you to the next measuring function, etc.
- Plug the red measuring line into the v measuring
jack (9) and the black measuring line into the COM
measuring jack (8).
- An approximate value of less than 50 Ohm is identi-
fied as continuity; in this case a beep sounds. The
measuring range is up to 500 Ohm.
- If “OL.” (overload) appears on the display, you have
exceeded the measuring range or the measuring
circuit is interrupted.
- Remove the measuring lines from the object to be
measured after completion of the measurement and
switch off the DMM.
Summary of Contents for 1380557
Page 3: ...3 ...
