OPERATING TIPS-MAINTENANCE AND STORAGE 16
1. Start the cordless snow shovel. Push the shovel forward at a comfortable rate, yet slow enough to clear the
path completely. The clearing width of the snow shovel and the depth of snowfall should dictate your forward
speed.
2. Direct the snow discharge to the right or to the left by holding the cordless snow shovel at a slight angle.
3. To remove snow most efficiently, throw the snow downwind and slightly overlap each swath.
4. If you need to clear snow from a crushed rock or gravel surface, push down on the handle to keep the
scraper blade clear of any loose material that the rotor blades could throw.
5. This cordless snow shovel cuts a path 11 in. (28 cm) wide and up to 6 in. (15 cm) deep in one pass.
6. When clearing deeper drifts, hold the cordless snow shovel by the upper and lower handles and use a
swinging or sweeping motion. Remove up to 6 in.(15 cm) of snow with each pass and repeat as many times
as needed.
7. Remove the battery after using the cordless snow shovel. Hang the shovel so it will not be misplaced or
damaged.
Before carrying out maintenance operations, remove the battery pack.
Regular cleaning and maintenance of your snow thrower will ensure efficiency and prolong the life of the
product.
After each use, take apart and clean out the ice and debris from the ventilator and its slots, the auger and the
housing.
Only use a cloth soaked with hot water and a soft brush to clean the snow thrower. Never wet or spray water
on the machine!
Do not use detergents or solvents as these could cause irreparable damage to the snow thrower.
Chemicals can destroy the plastic parts.
To protect the snow thrower from corrosion when storing for long periods, lightly oil the metal parts.
Store the appliance in a dry area out of reach of children.
For the user’s safety, worn or damaged parts must be replaced. Replace with original replacement parts only.
Parts from another snow thrower may not fit properly causing an unsafe situation.
1. Remove screws and take off the cover.
2. Remove the screw, washer, pulley frame, and belt from the pulleys.
3. Install the new belt in the same groove as the old one.
4. Replace the screw, washer, and pulley frame.
5. Replace the cover and secure it with screws.
OPERATING TIPS
MAINTENANCE AND STORAGE
Belt Replacement
IMPORTANT!
Always remove the battery from the tool before performing any maintenance on it.
Screws
Screws
Screws
Belt
