Insert the roller in the mounting adapter. You will feel
slight resistance to the roller as it is placed in the jig.
This is because of the rubber seal.
Push the roller until it is in contact with the inside of the
sleeve. You will feel extreme resistance at this point and
the roller cannot be pushed further into the adapter.
Note:
It is not necessary to use lubricants when using
the VOLTA adapter. At most a light spray of water will
make the mounting of long rollers easier.
Adjust the pressure regulator to 1 Bar. Open the air
pressure valve (5). Place the push bar (3) on the end of
the roller.
Note:
The amount of air pressure necessary to easily
mount a sleeve is a function of ambient air pressure,
smoothness of roller surface and the strength of the
technician. It requires a minimum of 1 Bar of air pressure
to mount the sleeve. Never exceed 3.5 Bar of air
pressure.
Press the push bar forward. The end of the roller inside
the sleeve will develop an air cushion between the roller
end and the inside of the sleeve.
If the sleeve does not slide in smoothly, increase the air
pressure slightly.
Continue pushing until the push bar (3) is flush with the
mounting adapter.
Note:
The push bar has a ridge with holes next to the
handle. The holes in this ridge are designed to release
air pressure and avoid the possibility of the push bar
being forced out of the jig and possibly causing injury
or damage.
Before releasing the push bar, turn off the air pressure
Pull the push bar out of the mounting adapter.
3
5
WARNING:
If the sleeve develops a bubble at
the point of attachment to the Adapter and the
roller is difficult to push, stop all actions and
check for problems
.
