VOLTA Sierra U4020, Instruction Manual

Page: 7 / 8

WARNING: On collection of proprietary carpet
conditioning powders, plaster/concrete dust, it is
recommended that the dust container is emptied
and the cartridge filter is cleaned after every use.
Some of the preparations contain substances which
while left in the vacuum cleaner for extended
periods could create damage.
Many air fresheners, household deodorants,
sprays and polishes contain highly inflammable
gas propellants. Because of this it is particularly
important that these products are used strictly
in accordance with the relevant manufacturers
instructions. It is essential that none of the above
products are sprayed directly into the vacuum
cleaner or any of the filters, hose assembly or
dust chamber.
TRouble shooTING ANd
cusTomeR INfoRmATIoN
You can perform your own troubleshooting
at home based on the checklist given below.
However, if the problem persists, please contact
Electrolux on 1300 365 305 (AUS)
or 0508 730 730 (NZ)
PRoblem PossIble cAuses coRRecTIoNs
Vacuum cleaner does
not start. Plug is not properly connected
to the socket. Check the plug connection or try another socket.
Thermal protector activated due
to high temperature. Press the On/Off button and wait 20-30 minutes
for the motor to cool down.
Filter indicator light
stays on. Dust container is full. Empty the dust container.
Filters are clogged. Clean or replace filters.
Reduction of suction
capacity. Suction hose is blocked. Clean the hose.
Nozzle is blocked. Clean the nozzle.
Dust container is full. Empty the dust container.
Filters are clogged. Clean or replace filters.
Hose is damaged or broken. Change the hose.
Over-heating. Dust container is full. Empty the dust container.
Filters are clogged. Clean or replace filters.
40933_U4020 Sierra_IFU_V2 OL.indd 7 2/07/12 10:50 AM