Getting the best results
k
Carpets:
Use the floor nozzle with the lever in
this position
J
Hard floors
: Use the floor nozzle with the lever in
this position
To avoid blockages and maintain suction efficiency, the
floor nozzles should be cleaned regularly using the
hose handle.
p
Loose rugs/curtains/lightweight fabrics:
Reduce the
suction power. Use the floor nozzle for loose rugs and
the upholstery nozzle for curtains, cushions etc.
r
Confined areas:
Use the crevice nozzle for crevices,
corners and radiators.
Dust bag indicator and changing the dust bag
For peak performance the dust bag must be changed
when full. Check the dust bag regularly and replace
when necessary.
To change the dust bag:
A Release catch and remove lid. Before removing the
dust bag, bend the tab into the hole to prevent dust
escaping.
B Remove the dust bag.
C Insert new dust bag by sliding the bag slots into the
holder. Close lid.
We recommend the dust bag is changed:
* after using a carpet cleaning powder
* if there is a bad smell from the cleaner, then you
should also change the filter
Dust bag safety device
To avoid damaging the cleaner, do not use it without a
dust bag. A safety device is fitted which prevents the
cover closing without a dust bag. Do not attempt to
force cover shut.
Changing/Cleaning the filters
There are two filters inside your cleaner. Never use the
cleaner without the filters in place.
To clean Motor Protection filter:
The Motor Protection filter should be cleaned when
dirty.
D) Release catch, remove lid and filter.
E) Wash filter in warm water.
F) Allow to dry and re-insert clean filter. Close lid.
To change Micro filter:
The Micro filter should be changed every fifth dust bag.
G) Release catch, open the filter cover and
remove filter.
H) Insert new filter and close cover.
Troubleshooting
1. Power:
If the electric power does not come on,
disconnect from mains
and check plugs, cable and
fuses where appropriate.
2. Blockages/dirty filters:
The cleaner may switch
itself off in the event of a severe blockage or
excessively dirty filter(s). In such cases, disconnect
from mains and allow to cool for 20-30 minutes.
Clear blockage and/or replace filter(s) and restart. The
clearing of blocked hoses is not covered by the
guarantee.
3. Water:
If water is sucked into the cleaner the motor
must be changed at a Service Centre.
For healthier homes
All manuals and user guides at all-guides.com
all-guides.com
Summary of Contents for Rolfy
