INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
[email protected] • 813.978.3700
VOLT
®
Salty Dog Brass MR16 Well Light
VWL-705-BBZ
–4–
–5–
Install Lamp
2
Remove Faceplate and Lens
1
Wire Connection
5
Install Lens and Faceplate
3
Dig Hole
4
3”
3”
3”
PVC Tube
Hole
Soil
Loosen the thumb screws and
slide the housing down to
the end of the bars. Unscrew
the screws and remove the
faceplate, gasket, and lens from
the housing.
Screw
Faceplate
Gasket
Lens
Thumb Screw
Housing
Insert the lamp with the correct
wattage and type marked on the
fixture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch lamp with
bare hands. Use soft cloth to handle
lamp.
MR16 Lamp
Socket
Place the lens, gasket and
faceplate back onto the housing.
Secure them with the screws
previously removed. Hand tighten
until snug, then use a screwdriver
to secure the screws using a star
pattern. Adjust housing to your
desired height and angle, then
secure it in place with the thumb
screws.
Screw
Faceplate
Gasket
Lens
Thumb Screw
Housing
Dig a hole in the ground making
sure there is approximately
3 inches of room on all sides
surrounding the PVC tube for pea
gravel or sand.
Place the fixture onto the PVC
Tube. Pass the luminaire pigtail
through the PVC tube.
Strip both leads from the
luminaire pigtail. Using two wire
connectors (sold seperately),
connect the leads from the
luminaire to main supply cable
leads.
PVC Tube
Wire Connector
Main Supply Wire
Soil
Pigtail
Fixture