INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
Wire Connection
2
Install Horseshoe Mount
1
VOLT
®
Salty Dog Brass LED Underwater Light
VUL-711-BBZ
–4–
Anchor
Horseshoe
Mount
Mounting
Screw
Washer
Strip both leads from the luminaire pigtail. Using wire connectors
(sold seperately), connect the leads from the luminaire to the main
supply cable leads.
Adjust the housing to your desired direction by using the lock nuts
on the side of the housing.
Thumb Screw
Wire Connector
Main Supply Wire
Pigtail
Housing
Place the horseshoe mount on the
desired location and mark (3) points
for the anchors from the holes on the
horseshoe mount.
Drill proper holes on the location and
insert anchors into the drilled holes.
Attach the horseshoe mount onto
the anchors. Pass the washers over
the mounting screws and thread the
mounting screws into the anchors to
secure the horseshoe mount. Hand
tighten until snug with a screwdriver.
NOTE: SOME APPLICATIONS ARE NOT
SUITABLE FOR PERMANENT MOUNTING AND
DO NOT REQUIRE OR WARRANT THE USE OF
SCREWS AND ANCHORS
